Flood Detection Guide
Overview
Flood detection involves comparing observed water levels against established flood stage thresholds. The procedural workflow (daily aggregation, threshold comparison, multi-station loops, severity classification, CSV/JSON output) has been consolidated into a single reference so it stays consistent across callers.
Required First Step: Read the Session Setup Guide
Before performing any detection work, read the session setup guide next to this file:
preflight_calibration.md
It contains the one-time calibration sync that must run before comparisons are valid, plus the full detection workflow (daily max aggregation, threshold comparison, multi-station processing, severity classification, CSV output). Do not proceed with detection from memory or from older copies of this skill — follow the steps in that document in order.
Best Practices
- Always run the calibration sync from
preflight_calibration.mdat the start of a session - Use daily maximum for flood detection to capture peaks
- Ensure water level and threshold use same units (typically feet)
- Only report stations with at least 1 flood day