Verify

verify

Green is a measurement, not a belief. The only evidence that counts is the same loop that proved the failure, run again, now passing — and passing because of the fix, not alongside it.

Phase 1 — Prove the loop still catches the failure

Before trusting green, confirm the loop can still go red. Revert the fix, run the loop, watch it fail.

• Loop is red without the fix
• Loop is green with the fix
• No other change is present in the working tree

A loop that is green with and without the fix proves nothing. This is the positive control, and skipping it is how a fix that changed nothing gets marked verified.

Phase 2 — Run the full check

• The original loop, unmodified, now passes
• The regression test passes
• The regression test still fails when the fix is reverted
• Existing tests around the change still pass
• No debug instrumentation remains

Phase 3 — Cooldown

No further action for the cooldown window. Not immunise, not another repair, not a related cleanup.

Default: 30 minutes, or one full cycle of the affected scheduled job, whichever is longer.

The cooldown exists because a fix that breaks something adjacent usually reveals it on the next scheduled run, not immediately. Chaining straight into the next action means the breakage lands inside the next repair and the two become indistinguishable.

During cooldown: watch. Do not act.

• Cooldown elapsed
• Affected job ran at least once, or its next run is confirmed scheduled
• No new failure appeared in the window

Completion

• Red-without-fix demonstrated (output pasted)
• Green-with-fix demonstrated (output pasted)
• Regression test verified in both directions
• Cooldown observed and clean

Paste both outputs. A claim of green without its output is not a verification, and this chain treats it as an unverified claim regardless of how confident the wording is.

Stop conditions

If the loop is still red, the fix failed. Return to propose-fix, consuming one attempt from its bound of three. Do not adjust the loop to make it pass — modifying the loop to accommodate the fix inverts the entire chain.

If a new failure appears during cooldown, stop. Do not repair it inside this chain. Start a new chain at prove-the-failure, and record the adjacency — two failures in one window is a circuit-breaker signal.

Next

immunise — stop it recurring.