Cis Ubuntu2004 V300 5 3 3 1 2

5.3.3.1.2 Ensure password unlock time is configured (Automated)

Profile Applicability

• Level 1 - Server
• Level 1 - Workstation

Description

unlock_time=<n> - The access will be re-enabled after seconds after the lock out. The value 0 has the same meaning as value never - the access will not be re-enabled without resetting the faillock entries by the faillock(8) command.

Note:

• The default directory that pam_faillock uses is usually cleared on system boot so the access will be also re-enabled after system reboot. If that is undesirable a different tally directory must be set with the dir option.
• It is usually undesirable to permanently lock out users as they can become easily a target of denial of service attack unless the usernames are random and kept secret to potential attackers.
• The maximum configurable value for unlock_time is 604800.

Rationale

Locking out user IDs after n unsuccessful consecutive login attempts mitigates brute force password attacks against your systems.

Impact

Use of unlock_time=0 may allow an attacker to cause denial of service to legitimate users. This will also require a systems administrator with elevated privileges to unlock the account.

Audit Procedure

Command Line

Run the following command to verify that the time in seconds before the account is unlocked is either 0 (never) or 900 (15 minutes) or more and meets local site policy:

# grep -Pi -- '^\h*unlock_time\h*=\h*(0|9[0-9][0-9]|[1-9][0-9]{3,})\b' /etc/security/faillock.conf

Expected output:

unlock_time = 900

Run the following command to verify that the unlock_time argument has not been set, or is either 0 (never) or 900 (15 minutes) or more and meets local site policy:

# grep -Pi -- '^\h*auth\h+(requisite|required|sufficient)\h+pam_faillock\.so\h+([^#\n\r]+\h+)?unlock_time\h*=\h*([1-9]|[1-9][0-9]|[1-8][0-9][0-9])\b' /etc/pam.d/common-auth

Expected Result

Nothing should be returned from the second command.

Remediation

Command Line

Set password unlock time to conform to site policy. unlock_time should be 0 (never), or 900 seconds or greater. Edit /etc/security/faillock.conf and update or add the following line:

unlock_time = 900

Run the following command: remove the unlock_time argument from the pam_faillock.so module in the PAM files:

# grep -Pl -- '\bpam_faillock\.so\h+([^#\n\r]+\h+)?unlock_time\b' /usr/share/pam-configs/*

Edit any returned files and remove the unlock_time=<N> argument from the pam_faillock.so line(s).

Default Value

unlock_time = 600

Additional Information

If a user has been locked out because they have reached the maximum consecutive failure count defined by deny= in the pam_faillock.so module, the user can be unlocked by issuing the command faillock --user <USERNAME> --reset. This command sets the failed count to 0, effectively unlocking the user.

References

None listed.

CIS Controls

MITRE ATT&CK Mappings