easyzoom CANopen Integration
Overview
Use this skill to debug CANopen by separating raw CAN bring-up, node identity, object dictionary, NMT state, SDO configuration, PDO mapping, heartbeat, and application semantics. CANopen cannot work reliably until raw CAN timing works.
When To Use
Use this skill when:
- The user is adding or debugging CANopen master/slave nodes, object dictionaries, EDS/DCF files, PDOs, SDOs, NMT, heartbeat, SYNC, or EMCY.
- The issue involves missing PDOs, SDO aborts, node state, heartbeat timeout, wrong COB-IDs, mapping errors, or network management.
- The implementation uses CANopenNode, a vendor stack, or a custom CANopen layer.
Do not use this skill for low-level CAN bit timing or transceiver bring-up. Use
canbus-integration first when raw CAN frames are not proven.
First Questions
Ask for:
- CANopen stack, node ID, bitrate, raw CAN evidence, and network topology.
- Object dictionary entries, EDS/DCF, PDO mapping, COB-IDs, and NMT state.
- Master tool or peer node, SDO abort codes, heartbeat settings, and logs.
- Whether SYNC, TIME, EMCY, LSS, or boot-up messages are required.
- Exact frame capture from a CAN analyzer if available.
Debug Workflow
Prove raw CAN. Confirm bitrate, sample point, transceiver, termination, and error counters.
Prove node identity. Check node ID, boot-up message, NMT state, heartbeat producer/consumer, and expected COB-IDs.
Validate object dictionary. Confirm index/subindex types, access rights, defaults, persistence, and application backing storage.
Debug SDO first. Use SDO reads/writes to verify OD entries before enabling PDO mapping.
Debug PDO mapping. Check mapping parameters, transmission type, inhibit/event timers, SYNC, and payload length.
Add safety behavior. Handle heartbeat loss, EMCY, bus-off recovery, and safe outputs explicitly.
Common Failures
- Raw CAN works only at another bitrate or with missing termination.
- Node ID conflicts with another node or creates unexpected COB-IDs.
- OD type/access flags do not match the master expectation.
- PDO mapping is changed while the PDO is enabled.
- Heartbeat consumer timeout is shorter than realistic bus or boot timing.
- Application updates OD values without atomicity or endian consistency.
Verification
Before claiming CANopen works:
- State bitrate, node ID, stack, NMT state, and object dictionary source.
- Confirm boot-up, heartbeat, and SDO read/write of key OD entries.
- Confirm PDO mapping and timing with a CAN trace.
- Confirm heartbeat timeout, EMCY, or bus-off behavior if safety-related.
Example
User:
CANopen 主站读 SDO 返回 abort。
Agent:
- Captures the abort code, index/subindex, node ID, and COB-ID.
- Checks OD type, access rights, and backing variable.
- Verifies raw CAN and NMT state before changing application logic.