plurigrid Puffco Proxy
Modular concentrate vaporizer. State machine for session management.
Hardware
- Device: Puffco Proxy (modular pipe + removable 3D chamber)
- Chamber: 3D ceramic, 3-prong alignment to base
- Glass: Modular borosilicate pipe attachment
- Charging: USB-C, ~90 min full charge, ~15 sessions/charge
- App: Puffco Connect (Bluetooth, custom boost profiles)
Heat Settings
| Color | Temp °F | Label | Character |
|---|---|---|---|
| 🔵 Blue | ~490 | LOW | High flavor, low vapor |
| 🟢 Green | ~510 | MED | Balanced (daily driver) |
| 🔴 Red | ~530 | HIGH | Strong vapor, good flavor |
| ⚪ White | ~565 | PEAK | Maximum extraction |
Button Language
| Action | Effect |
|---|---|
| Hold 3s | Power on / off |
| 1x click | Cycle heat setting (blue→green→red→white→blue) |
| 2x click | Initiate heat cycle / Boost mode (during session) |
| 3x click | Battery check (green 60-100%, yellow 30-59%, red 0-29%) |
LED Indicators
| Pattern | Meaning |
|---|---|
| Pulsing color | Heating in progress |
| Solid color + vibrate 3x | Ready to draw |
| 3 white flashes | Chamber misaligned — reseat |
| Solid red 5s | Overheating — cool down |
| Pulsing green (charging) | Charge in progress |
| Light off (charging) | Fully charged |
State Machine
12 states, defined in worlds/g/puffco_proxy_state_machine.py:
OFF → IDLE → HEATING → READY → SESSION → COOLING → IDLE
↓
BOOST → COOLING
Setup path: IDLE → BATTERY_CHECK, IDLE → HEAT_SELECT, IDLE ↔ CHAMBER_ERROR
CLI
# Full session walkthrough
bb worlds/g/puffco_proxy.bb session
# Session with boost
bb worlds/g/puffco_proxy.bb boost
# Best practices
bb worlds/g/puffco_proxy.bb tips
# Heat settings
bb worlds/g/puffco_proxy.bb heat
# Graphviz DOT output
bb worlds/g/puffco_proxy.bb dot
# Interactive REPL
bb worlds/g/puffco_proxy.bb
Best Practices
Loading
- Cold load only — never load while chamber is hot
- Place concentrate along chamber WALLS, not bottom center
- Rice-grain sized amount — overpacking causes leakage into base
- Seat carb cap snug before heating
Drawing
- Hold device UPRIGHT / VERTICAL
- Inhale gently — slow steady draw maximizes vapor
- Start at Green, adjust from there
Cleaning (critical for longevity)
- Every session: swab chamber with dry cotton while warm
- Weekly: soak chamber + glass in 90%+ isopropyl 20-30 min
- Base: swab contact points only, never flood with liquid
- Air dry all components completely before reassembly
Safety
- Max 4 consecutive heat cycles before mandatory cooldown
- Solid red 5s = overheating protection engaged
- 3 white flashes = reseat chamber (3-prong alignment)
World
- Letter: G
- Location:
worlds/g/puffco_proxy.bb