vamseeachanta Error Handling
Error Handling
# Handle damping analysis errors
try:
sweep = DampingSweep()
sweep.load_model("models/fpso.owr")
results = sweep.run(parameter="roll_damping", values=[0.05, 0.10])
except DampingOutOfRangeError as e:
print(f"Damping value unrealistic: {e}")
# Typical range 1-20% critical
except NegativeDampingError as e:
print(f"Negative damping detected: {e}")
# Check model setup
except ConvergenceError as e:
print(f"Analysis did not converge: {e}")
# Reduce damping or check mesh